Perancangan dan Pembuatan Prototype Turbin Angin Archimedes

Abstract

Wind is an unlimited source of energy which is expected to be a substitute energy source or alternative energy. The use of wind energy in Indonesia is still very small, especially in the field of electricity generation. A 3-dimensional printer is a printing technology using a special printing machine so that the results obtained are in 3D form. The printing machine has a special sophistication, which is capable of printing objects, which are exactly the same as the soft file image, in 3D Designing the Archimedes Wind Turbine using solidwork Making the Archimedes Wind Turbine with a 3-dimensional printer Knowing the material strength of the prototype Archimedes Wind Turbine Turbine design Archimedes took the shape of a conch, and a spiral. With a shaft diameter of 12 mm, a radius of 4 mm and a shaft distance with turbine fins 5.56 mm, the length of the Archimedes Wind Turbine shaft was 135 mm, the time required to print on a 3D printer was 11 hours 4 minutes. , the filament used is 11.10m/88g using a speed mul 60-60-100°C and a flow mul 100°C the temperature used to print the Archimedes Wind Turbine in this case the voltage generated is 1.085e+006 N/m² while the The allowable value is 2x10⁹ N/m² so that the components are ensured to be safe because the stresses that arise are less than the tested stresses n. Archimedes Wind Turbine With the explanation above, it is stated that the Archimedes Wind Turbine is safe to work well for the strength of the material.